Use this kit to install any Micro USB 5 volts Dashcam into you vehicle with both front and rear power leads.
It will monitor your vehicle battery and cut the power to the camera when the battery reaches the set voltage. You can also wire in the ACC lead to specify the time that parking mode is recording for.
- Easy and fast installation
- Vehicle Battery protection for low voltage and timer function to prevent discharge (various selectable voltages)
- 2 x supply leads for both front and rear camera:
- 1 x 2mtr cable with right angle micro USB connector
- 1 x 2mtr cable with female USB connector
- 5 volt 2.5 amp (total) supply
INSTALLATION INSTRUCTIONS:
Red Wire - connect to a permanent 12/24 volt feed
Yellow Wire - connect to a switched (ACC) 12/24 volt feed
Black Wire - connect to Ground
Dip Switches 1 to 4 are selected according to the Voltage Protection
Switches 5 to 8 are selected acording to the length of time for parking mode (it is suggested to enable 12 or 24hr for optimum performance)
We offer a fuse cable & fuse for wiring this into your vehicle.
Please note that only the RED 12v cable is recommended to have a fuse.
SPECIFICATIONS:
| Model No | TABM-1 |
| Input | 12V-24V |
| Output | 5V/2.5A |
| Fuse Type: | 63V/3A |
| Car Low Voltage Protection (selectable) | 11.5V, 12V, 12.5V, 13V |
| Parking Model Timer Function | 12hr, 24hr, 48hr, infinite |
Reviews
Bought this for the dash cam i bought off amazon after the amazon seller sold me a cheap unit that flattened my car battery.
I like the fact you can have low voltage setting AND a timer too. works well with a red light showing if its on or not.